Ballast Resistor Wiring Diagram Points

If you buy the mopar performance electronic ignition system it comes with extensive instructions wiring diagrams and other information.

Ballast resistor wiring diagram points.
Resistors wiring diagrams duration.
According to the wiring diagram i have it goes to the ignition switch.
In simple terms the ballast resistor in a mopar limits the amperage or current flow through the coil while the engine is running thereby extending the life of the coil and breaker points of.

I dont know if it has a primary resistance wire.
The job of the ballast resistor was to inhibit current to a level that would not overheat the coil.
Im assuming they mean a ballast resistor.

The typical automotive ignition system prior to 1974 consisted of a coil and ballast resistor with breaker points to interrupt the current flow when a spark was needed.
In the years when engines were a lot easier to work with a ballast resistor was used in order to prolong the life of the coil.
Are there any changes that i need to make in my wiring and connections.

You only need a ballast resistor if you have a 12 volt system and points.
Of course this meant that there was going.
Thanks for your feed back.

My 68 corvette has a resistor wire vs a ballast resistordoes the same thingcuts the volts to the points to about 8 volts.
How to wire mid 1970s through mid 1980s ignition systems retrofitting electronic ignition on vehicles that originally had points.
The points distributor used a resistance to lower the voltage to the points in the run position to prevent wear on the points.

I didnt see anything like a ballast resistor but it could be under the dash.
In a points type ignition the ballast resistor would help to keep the spark down and the coil from being burned up too quickly.
All my videos are in 1080p hi def so check that out just an idea on how the gm breaker points style distributor is wired thanks for watching and please subscribe.

I have looked up wiring diagrams online and havent seen any with a ballast resistor on the diagram.
It has some wires that are melted and a new wire harness is in the plans ahead.
I am planning to replace the distributor with a mallory unilite pointless distributor the instructions emphasize the necessity of either a ballast resistor or a loom resistance wire between the ignition switch and the coil.

This was done with either an external ballast resistor or a resistance wire in the ignition circuit depending on the year of the car.
Main index forum index.
How do i wire a ballast resistor coil.

For additional how to tutorials visit our website.
This video explains how the ballast resistor works.